08125500 – GEN2 Bearing Fitting & Removing Instrument
Built for fitting and removing contemporary (GEN2) Wheel Hub Bearing Units – in which the Hub & Bearing are a combined unit
■Use on SKF HBU two.1 wheel bearings for dismounting & mounting
■Use on FAG (GEN2) wheel bearings for dismounting & mounting
■For motor vehicles with 72mm bearings
•Audi A2 2000-
•Seat / Ibiza / Cordoba 2002-
•Skoda Fabia / Roomster 2000-
•VW Polo 2002- / VW Fox 2005-
Pertinent Bearings: SKF VKBA 3368 / VKBA 6635 / FAG 713 6108 60
Wheel Hub Bearing Unit Removing:
Employing the 08125500 package helps make it feasible to safely get rid of the aged unit in-situ. It is vital that the aged unit is taken out at the suitable angle, to prevent problems to the housing and the Sykes-Pickavant 08125500 package guarantees the suitable angle for removing.
Wheel Hub Bearing Set up:
It is important to make certain that there is no problems to the locking ring when fitting new units into the bearing housing. If the locking ring gets to be damaged, there is a superior chance that the bearing and hub will grow to be separated, causing untimely failure. The 08125500 package guarantees that the locking ring will not grow to be damaged.
Take note: The Wheel Hub Unit Have to be pushed on the outer bearing ring, powering the locking crown. Employing a push on the centre flange
will bring about untimely bearing failure, or damage the bearing although installing.
Post time: Nov-20-2016